Dynamic Random-Access Memory (DRAM)

A Dynamic Random-Access Memory (DRAM) is a random-access memory that store data bits into separate capacitors.

• Example(s):
  • Synchronous DRAM.
  • …
• Counter-Example(s):
  • Static Random-Access Memory.
• See: Memory Cell (Binary), Random-Access Memory, Bit, Capacitor, Integrated Circuit, Memory Refresh, Flash Memory, Volatile Memory, Non-Volatile Memory, Data Remanence, Main Memory.

---

---

References

2017

• (Wikipedia, 2017) ⇒ https://en.wikipedia.org/wiki/Dynamic_random-access_memory Retrieved:2017-7-1.
  • Dynamic random-access memory (DRAM) is a type of random-access memory that stores each bit of data in a separate capacitor within an integrated circuit. The capacitor can be either charged or discharged; these two states are taken to represent the two values of a bit, conventionally called 0 and 1. Since even "nonconducting" transistors always leak a small amount, the capacitors will slowly discharge, and the information eventually fades unless the capacitor charge is refreshed periodically. Because of this refresh requirement, it is a dynamic memory as opposed to static random-access memory (SRAM) and other static types of memory. Unlike flash memory, DRAM is volatile memory (vs. non-volatile memory), since it loses its data quickly when power is removed. However, DRAM does exhibit limited data remanence.

    DRAM is widely used in digital electronics where low-cost and high-capacity memory is required. One of the largest applications for DRAM is the main memory (colloquially called the "RAM") in modern computers; and as the main memories of components used in these computers such as graphics cards (where the "main memory" is called the graphics memory). In contrast, SRAM, which is faster and more expensive than DRAM, is typically used where speed is of greater concern than cost, such as the cache memories in processors.

    The advantage of DRAM is its structural simplicity: only one transistor and a capacitor are required per bit, compared to four or six transistors in SRAM. This allows DRAM to reach very high densities. The transistors and capacitors used are extremely small; billions can fit on a single memory chip. Due to the dynamic nature of its memory cells, DRAM consumes relatively large amounts of power, with different ways for managing the power consumption.

---